Factors to Consider When Designing a Volute Pump Body

Oct. 14, 2020

In the volute design, the most important design variable is the area of the throat. This area and the area of the impeller outlet determine the optimal operating point of the pum...

Six Common Causes of Defects in Wet Casting (Part 2)

Sep. 30, 2020

Shrinkage porosity and shrinkage reduce the effective bearing area of the casting.

Six Common Causes of Defects in Wet Casting (Part 1)

Sep. 23, 2020

The small gray cast iron scraps in the wet small workshop are mainly caused by defects such as blisters, sand sticking and pores.

What Are the Differences Between Metal Castings and Forgings?

Sep. 17, 2020

Forging and casting are two common processes for processing advanced metal forgings.

The General Law Affecting Ductile Iron Shrinkage

Sep. 11, 2020

In the actual casting technology work, it is of very important guiding significance to solve the shrinkage phenomenon of ductile iron castings.

What Are the Causes of Cracks in High Manganese Steel Castings? (Part 2)

Sep. 08, 2020

High manganese steel casting can only obtain its characteristics under the right composition and correct heat treatment conditions.